The Arlec FL052HA security flood light is part of the Grid Connect ecosystem and is sold at Bunnings in Australia.
As of the time of writing, versions
1219 can be flashed using tuya-convert, however if it is version
0520 OTA flashing will not work.
You can check these versions by looking at the bottom left of the Arlec product plaque. See below examples;
|GPIO14||LED Light (Monochromatic)|
Getting it up and running
As the flood lights do not have any physical buttons, you will follow the same flashing method that a Tuya Edison or Bayonet bulb will follow by turning the flood light on and off three times. This will cause the flood light to start flashing indicating you have entered pairing mode.
- Connect and disconnect power from flood light three times.
- Flood light will start flashing - this indicates the device has entered pairing mode successfully and is ready to see tuya-convert.
- Follow tuya-convert flashing procedure.
# Basic Config esphome: name: fl052ha_flood_light platform: ESP8266 board: esp01_1m wifi: ssid: "SSID" password: "password" ap: ssid: "fl052ha_flood_light" password: "m1H32D5zmNGU" captive_portal: logger: api: password: "password" ota: password: "password" output: - platform: esp8266_pwm pin: GPIO14 frequency: 1000 Hz id: pwm_output light: - platform: monochromatic output: pwm_output name: "fl052ha_flood_light"